My SIP Switch

Hi all,

Here are some screen shots of the configuration interface of a Grandstream Handytone 286 ATA that with indications on how to set it up with My SIP Switch service.
Note that it is very similar to Budget Phone 100 / 101 configuration screens.

Thanks a lot to Luc for the screen shots.

Note that the IP settings are specific here. This ATA is connected behind a Linksys WR54G router with NAT enabled ! You will want to change that depending on your network configuration.

The DHCP options means that the IP settings will be assigned dynamically by the router. It may be handier for less technical people.

The DNS values are specific to your broadband provider so mind these  values.

Note that the “local SIP Port” has been changed here for a specific reason. 5060 is in most cases fine. You need to make sure that the router which is in front of this ATA allows SIP traffic on this port.

The STUN server can be changed of course. There are a bunch of free ones you can use (see : http://www.voip-info.org/wiki-STUN)

Press Update and give it a go !

On the status page, you should see the SIP packets getting through and RTP ones if you are making calls.

You can also take a look at the configuration guide on Blueface’s site : HandyTone286 Configuration

Any questions , refer to our Technical Forum